A/T Doesn't Shift: 2(2)->1(1), W/Sel. Lever 2->1 Pos.

19. A/T Does Not Shift: 2(2) -> 1(1), When Selector Lever 2 -> 1 Position

SYMPTOM:
^ A/T does not shift from 2(2) to 1(1) when changing selector lever from 2 to 1 position.

1. CHECK PNP SWITCH CIRCUIT

With CONSULT





Does "TCM INPUT SIGNALS" in Data Monitor show damage to PNP switch circuit?

Without CONSULT
Does self-diagnosis show damage to PNP switch circuit?

Yes or No
Yes >> Check PNP switch circuit. Refer to "DTC P0705 PARK/NEUTRAL POSITION (PNP) SWITCH".
No >> GO T0 2.

2. CHECK SYMPTOM





Check again.
OK or NG
OK >> INSPECTION END.
NG >>
1. Perform TCM input/output signal inspection.
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.