Diagnosis Function and Mode

DIAGNOSIS FUNCTION
The SRS self-diagnosis results can be read by using "AIR BAG" warning lamp and/or CONSULT-II. The reading of these results is accomplished using one of two modes "User mode" and "Diagnosis mode". The User mode is exclusively prepared for the customer (driver). This mode warns the driver of a system malfunction through the operation of the "AIR BAG" warning lamp.






The Diagnosis mode allows the technician to locate and inspect the malfunctioning part. The mode applications for the "AIR BAG" warning lamp and CONSULT-II are shown.

NOTE: Seat belt pre-tensioner malfunction is indicated by "AIR BAG" warning lamp.

DIAGNOSIS MODES FOR CONSULT-II

"SELF-DIAG [CURRENT]"
A current Self-diagnosis result (also indicated by the number of warning lamp flashes in the Diagnosis mode) is displayed on the CONSULT-II screen in real time. This refers to a malfunctioning part requiring repairs.

"SELF-DIAG [PAST]"
Diagnosis results previously stored in the memory are displayed on the CONSULT-II screen. The stored results are not erased until memory erasing is executed.

"TROUBLE DIAG RECORD"
With TROUBLE DIAG RECORD, diagnosis results previously erased by a reset operation can be displayed on the CONSULT-II screen.


"ECU DISCRIMINATED NO."
The diagnosis sensor unit for each vehicle model is assigned with its own, individual classification number. This number will be displayed on the CONSULT-II screen. When replacing the diagnosis sensor unit, refer to the part number for the compatibility. After installation, replacement with a correct unit can be checked by confirming this classification number on the CONSULT-II screen.


STARTING DIAGNOSIS MODE FOR CONSULT-II
1. Turn ignition switch "OFF".






2. Connect CONSULT-II to data link connector.






3. Turn ignition switch "ON".
4. Touch "START".






5. Touch "AIR BAG".







6. For "SELF-DIAG [CURRENT]".






a. Touch "SELF-DIAG [CURRENT]".






b. Diagnostic codes are displayed on "SELF-DIAG [CURRENT]".


7. For "SELF-DIAG [PAST]".






a. Touch "SELF-DIAG [PAST]".






b. If diagnostic codes are displayed on "SELF-DIAG [PAST]", go to step "d".






c. If no malfunction is detected on "SELF-DIAG [PAST]", touch "BACK" and go back to "SELECT DIAG MODE".






d. Touch "TROUBLE DIAG RECORD".

NOTE: With "TROUBLE DIAG RECORD", diagnosis results previously erased by a reset operation can be displayed.


8. Touch "COPY".

9. Compare diagnostic codes to "CONSULT-II Diagnostic Code Chart".
CONSULT-II Display Items ("Self-Diag [Current]")

10. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears in order to return to User mode from Diagnosis mode.

11. Turn ignition switch "OFF", then turn off and disconnect CONSULT-II, and disconnect both battery cables.

12. Repair the system as outlined by the "Repair order" in "CONSULT-II Diagnostic Code Chart", that corresponds to the self-diagnostic result. For replacement procedure of component parts, refer to the applicable Removal and Installation procedure.

13. After repairing the system, refer to "DIAGNOSTIC PROCEDURE 3" for final checking.
Diagnostic Procedure 3