Passenger Air Bag Deactivation Switch

Passenger Air Bag Deactivation Switch
Removal

Before servicing SRS, turn the ignition switch OFF, disconnect both battery cables and wait for at least 3 minutes.

1. Remove cluster lid-C.
Refer to Instrument Panel, "Removal and Installation".
Instrument Cluster / Carrier

2. Disengage the two locking tabs from the passenger air bag deactivation switch lock cylinder and remove passenger air bag deactivation switch.


Installation

CAUTION: Passenger air bag deactivation switch is keyed for proper installation. Improper positioning of the switch will result in damage to the switch.

NOTE: Be sure that the passenger air bag deactivation switch and lock cylinder is connected and in the same position as during removal for proper engagement.
To install, reverse removal procedure.
After replacement, perform self-diagnosis for SRS. Refer to "SRS Operation Check". [1][2]Component Tests and General Diagnostics