Main Gear

Main Gear

DISASSEMBLY
Main Gear Bearing





1. Remove snap ring.





2. Remove main gear bearing using puller and Tool, as shown.

Plug





Remove plug using a drift or suitable tool, as shown.
^ Always replace plug with a new one whenever it has been removed.

INSPECTION
Gear, Shaft and Bearing





^ Check gears for excessive wear, chips or cracks.
^ Check shaft for cracks or wear.
^ Make sure bearings roll freely and are free from noise, cracks, pitting or wear.

ASSEMBLY
Main Gear Bearing





1. Press on main gear bearing.





2. Select and install snap ring with proper thickness.
^ Allowable clearance between snap ring and groove: 0 - 0.15 mm (0 - 0.0059 inch)
^ Available snap ring for main gear bearing: Refer to Specifications.

Plug





^ Apply sealant to plug, then install using a drift or suitable tool, as shown.
^ Use Genuine Anaerobic Liquid Gasket or equivalent.