P0101
DTC P0101 MAF SENSORComponent Description
The mass air flow sensor is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. It consists of a hot film that is supplied with electric current from the ECM. The temperature of the hot film is controlled by the ECM a certain amount. The heat generated by the hot film is reduced as the intake air flows around it. The more air, the greater the heat loss. Therefore, the ECM must supply more electric current to maintain the temperature of the hot film as air flow increases. The ECM detects the air flow by means of this current change.
Consult-II Reference Value In Data Monitor Mode:
On Board Diagnosis Logic:
DTC Confirmation Procedure
Perform "PROCEDURE FOR MALFUNCTION A" first.
If the DTC cannot be confirmed, perform "PROCEDURE FOR MALFUNCTION B".
NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch "OFF" and wait at least 10 seconds before conducting the next test.
PROCEDURE FOR MALFUNCTION A
NOTE: If engine will not start or stops soon, wait at least 10 seconds with engine stopped (Ignition switch "ON") instead of running engine at idle speed.
With CONSULT-II
1. Turn ignition switch "ON".
2. Select "DATA MONITOR" mode with CONSULT-II.
3. Start engine and warm it up to normal operating temperature.
4. Run engine for at least 10 seconds at idle speed.
5. If DTC is detected, go to "Diagnostic Procedure" below.
With GST
Follow the procedure "With CONSULT-II" above.
PROCEDURE FOR MALFUNCTION B
CAUTION: Always drive vehicle at a safe speed.
With CONSULT-II
1. Turn ignition switch "ON".
2. Start engine and warm it up to normal operating temperature.
If engine cannot be started, go to "Diagnostic Procedure" below.
3. Select "DATA MONITOR" mode with CONSULT-II.
4. Check the voltage of "MAS A/F SE-B1" with "DATA MONITOR".
5. Increases engine speed to about 4,000 rpm.
6. Monitor the linear voltage rise in response to engine speed increases.
If NG, go to "Diagnostic Procedure" below. If OK, go to following
7. Maintain the following conditions for at least 10 consecutive seconds.
8. If DTC is detected, go to "Diagnostic Procedure" below.
Overall Function Check
PROCEDURE FOR MALFUNCTION B
Use this procedure to check the overall function of the mass air flow sensor circuit. During this check, a 1st trip DTC might not be confirmed.
With GST
1. Start engine and warm it up to normal operating temperature.
2. Select "MODE 1" with GST.
3. Check the mass air flow sensor signal with "MODE 1".
4. Check for linear mass air flow sensor signal value rise in response to increases to about 4,000 rpm in engine speed.
5. If NG, go to "Diagnostic Procedure" below.
EC-MAFS-01:
Wiring Diagram
Diagnostic Procedure Step 1 - 2:
Diagnostic Procedure Step 3 - 5:
Diagnostic Procedure Step 6 - 10:
Diagnostic Procedure
Component Inspection
MASS AIR FLOW SENSOR
1. Reconnect all harness connectors disconnected.
2. Start engine and warm it up to normal operating temperature.
3. Check voltage between ECM terminal 51 (Mass air flow sensor signal) and ground.
4. If the voltage is out of specification, proceed the following.
- Turn ignition switch "OFF".
- Disconnect mass air flow sensor harness connector and reconnect it again.
- Perform steps 2 and 3 again.
5. If NG, remove mass air flow sensor from air duct. Check hot film for damage or dust.
6. If NG, clean or replace mass air flow sensor.