With Manufacturer Scan Tool (CONSULT-II)

With CONSULT-II

1. After repairing SRS, connect both battery cables.






2. Connect CONSULT-II to Data link connector.
3. Turn ignition switch from "OFF" to "ON".






4. Touch "START".






5. Touch "AIR BAG".






6. Touch "SELF-DIAG [CURRENT]".






7. If no malfunction is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Go to step 8.






8. Touch "ERASE".

NOTE: "ERASE" clears the memory of the malfunction ("SELF-DIAG [PAST]").
If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.


NOTE: If any malfunction is displayed on "SELF-DIAG [CURRENT]", the malfunctioning part is not repaired completely or another malfunctioning part is detected. Go to DIAGNOSTIC PROCEDURE 2, and repair malfunctioning part completely.

NOTE: The memory of "TROUBLE DIAG RECORD" cannot be erased.






NOTE: If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.