Manual Shaft

MANUAL SHAFT





Components

Removal





1. Remove detent spring from transmission case.





2. Drive out manual plate retaining pin using Tool.





3. Drive and pull out parking rod plate retaining pin using Tool.
4. Remove parking rod plate from manual shaft.
5. Draw out parking rod from transmission case.





6. Pull out manual shaft retaining pin.





7. Remove manual shaft and manual plate from transmission case.
8. Remove manual shaft oil seal

Inspection
^ Check component parts for wear or damage. Replace if necessary.

Installation





1. Install manual shaft oil seal using a suitable tool.
^ Apply ATF to outer surface of oil seal.





2. Install manual shaft and manual plate.





3. Align groove of manual shaft and hole of transmission case.
4. Install manual shaft retaining pin using Tool.





5. Install parking rod to parking rod plate.
6. Set parking rod assembly onto manual shaft.





7. Drive in manual plate retaining pin and parking rod plate retaining pin using Tool.





8. Install detent spring.
: 6.4 - 7.5 Nm (0.65 - 0.76 kgf-cm, 56.4 - 66.0 inch lbs.)