P0600

DTC P0600 A/T COMMUNICATION LINE

System Description
These circuit lines are used to control the smooth shifting up and down of A/T during the hard acceleration/deceleration.

Voltage signals are exchanged between ECM and TCM (Transmission Control Module).

On Board Diagnosis Logic:

On Board Diagnosis Logic

DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 5 seconds before conducting the next test.

WITH CONSULT-II
1. Turn ignition switch ON.




2. Select "DATA MONITOR" mode with CONSULT-II.
3. Start engine, and rev engine more than 1,000 rpm once, then let it idle for more than 40 seconds.
4. If DTC 1st trip is detected, go to "Diagnostic Procedure" below.

WITH GST
Follow the procedure "WITH CONSULT-II".

EC-AT/C-01:

EC-CAN-01:

Wiring Diagram

Diagnostic Procedure

Diagnostic Procedure (Steps 1 - 3):

Diagnostic Procedure (Steps 4 - 5):