ABS
Inspection 6 - Stop Lamp Switch and CircuitC1116 - STOP LAMP SW
1. CHECKING SELF-DIAGNOSIS RESULTS
Check self-diagnosis results.
Self-diagnosis results
CONSULT-II display items
STOP LAMP SW
Does "STOP LAMP SW" appear in self-diagnosis results display?
YES >> GO TO 2.
NO >> Inspection is completed.
2. CHECKING STOP LAMP
1. Disconnect stop lamp switch connector and ABS actuator and electric unit (control unit) connector.
2. Reconnect connectors securely.
3. Start engine.
4. Repeat pumping brake pedal carefully several times, then perform self-diagnosis again.
Do any self-diagnosis items appear?
YES >> GO TO 3.
NO >> Poor connection. Repair or replace the applicable connector.
3. CHECKING STOP LAMP SWITCH CIRCUIT
1. Disconnect stop lamp switch connector and ABS actuator and electric unit (control unit) connector.
2. Check continuity between stop lamp switch harness connector M47 and ABS actuator and electric unit (control unit) harness connector E39.
Is inspection result OK?
OK >> Perform ABS actuator and electric unit (control unit) self-diagnosis again.
NG >> Open or short in harness between ABS actuator and electric unit (control unit) and stop lamp switch.