Clearing Trouble Codes

HOW TO ERASE SELF-DIAGNOSTIC RESULTS (MALFUNCTION CODES)





1. Disconnect data link connector terminal 9 from ground (ABS warning lamp will stay lit).
2. Within 12.5 seconds, ground the data link connector terminal 9 three times. Each terminal ground must last more than 1 second. The ABS warning lamp turns off after the erase operation has been completed.
3. Perform self-diagnosis again. Refer to BRC-22, "SELF-DIAGNOSIS PROCEDURE". Without Scan Tool Only the start code should appear, no malfunction codes.

After the erase operation is completed, it is necessary to repeat the self-diagnostic procedure to verify that malfunction codes no longer appear. Only the start code (12) should be indicated when erase operation is completed and system is functioning normally.

NOTE: The TCS OFF indicator lamp and ABS warning lamp remain on.