Oil Pump

Oil Pump
DISASSEMBLY





1. Remove seal rings.

NOTE: Do not reuse seal rings.





2. Loosen bolts in a criss-cross pattern and remove oil pump cover.





3. Remove inner and outer gear from oil pump housing.





4. Remove O-ring from oil pump housing.

NOTE: Do not reuse O-rings.





5. Remove oil pump housing oil seal using suitable tool.

INSPECTION
Oil Pump Housing, Oil Pump Cover, Inner Gear and Outer Gear
Check component parts for wear or damage. Replace if necessary.

Side Clearances





Measure side clearance of inner and outer gears in at least four places around each outside edge. Maximum measured values should be within specified positions.
Standard clearance: 0.030 - 0.050 mm (0.0012 - 0.0020 inch)
If clearance is less then specification, select inner and outer gear as a set so that clearance is within specifications.
Inner and outer gear: Refer to "SERVICE DATA AND SPECIFICATIONS (SDS)".
If clearance is more than standard, replace whole oil pump assembly except oil pump cover.





Measure clearance between outer gear and oil pump housing.
Standard clearance: 0.111 - 0.181 mm (0.0044 - 0.0071 inch)
Allowable limit: 0.181 mm (0.0071 inch)
If not within allowable limit, replace whole oil pump assembly except oil pump cover.

Seal Ring Clearance





Measure clearance between seal ring and ring groove.
Standard clearance: 0.1 - 0.25 mm (0.0039 - 0.0098 inch)
Allowable limit: 0.25 mm (0.0098 inch)
If not within allowable limit, replace oil pump cover assembly.

ASSEMBLY





1. Install new oil seal on oil pump housing.
Tool number: ST33400001 (J-26082)





2. Install new O-ring on oil pump housing.

NOTE: Apply ATF to new O-ring.





3. Install inner and outer gears on oil pump housing.

CAUTION: Be careful of the direction of inner gear





4. Install oil pump cover on oil pump housing.
a. Wrap masking tape around splines of oil pump cover assembly to protect seal. Position oil pump cover assembly on oil pump housing assembly, then remove masking tape.
b. Tighten bolts in a crisscross pattern. Tighten oil pump cover bolts to the specified torque. Refer to "COMPONENTS".





5. Install new seal rings carefully after packing ring groove with petroleum jelly.

CAUTION: Do not spread gap of the seal ring excessively while installing, The ring may be deformed.

NOTE:
^ Do not reuse seal rings.
^ Apply petroleum jelly to new seal rings.