Timing Components: Specifications

Timing Chain Tensioner








A/T Models








M/T Models

Image Symbols:

Timing Cover





Tighten mounting bolts to the specified torque in numerical order as shown in the figure.
There are two type of mounting bolts. Refer to the following for locating bolts.
M8 bolts: 1, 2 25.5 - 31.3 Nm (2.6 - 3.2 kg-m, 19 - 23 ft. lbs.)
M6 bolts: Except the above 11.7 - 13.7 Nm (1.2 - 1.4 kg-m, 9 - 10 ft. lbs.)

NOTE: Figure shows A/T models.

After all bolts tightened, retighten them to the specified torque in numerical order as shown in the figure.

Crankshaft Pulley
Tighten crankshaft pulley bolt.
Torque 39.2 - 49.0 Nm (4.0 - 5.0 kg-m, 29 - 36 ft. lbs.)





Turn crankshaft pulley bolt 84 to 90° clockwise [Target: 90° (angle tightening)].

CAUTION: Check the tightening angle by using the angle wrench [SST]. Avoid judgement by visual inspection without SST.

Check tightening angle indicated on the angle wrench indicator plate.
Rotate crankshaft pulley in normal direction (clockwise when viewed from engine front) to confirm it turns smoothly.