Without Scan Tool

OPERATION PROCEDURE

1. While pressing the odo/trip meter switch, turn ignition switch ON.
2. Make sure that the trip meter displays "0000.0".
3. Press the odo/trip meter switch at least 3 times (within 7 seconds after the ignition switch is turned ON).




4. All the segments on the trip computer illuminate. At this time, the triple meter is turned to self-diagnosis mode.

NOTE: If any of the segments is not displayed, replace triple meter.




5. Press the odo/trip meter switch. voltmeter and oil pressure gauge should indicate as shown in the figure while pressing odo/trip meter switch.

NOTE: If voltmeter or oil pressure gauge is not activated, replace triple meter.