Part 1

Assembly (1)





1. As shown in the right figure, use a drift [commercial service tool [diameter]22 mm (0.87 inch)] to drive manual shaft oil seals into the transmission case until it is flush.

CAUTION:
^ Do not reuse manual shaft oil seals.
^ Apply ATF to manual shaft oil seals.





2. Install detent spring and spacer in transmission case.
Torque: 7.9 Nm (0.81 kg-m, 70 inch lbs.)





3. Install manual shaft to transmission case.





4. Install parking rod to manual plate.





5. Install manual plate (with parking rod) to manual shaft.
6. Install retaining pin into the manual plate and manual shaft.
a. Fit pinhole of the manual plate to pinhole of the manual shaft with a pin punch.





b. Use a hammer to tap the retaining pin into the manual plate.

CAUTION:
^ Do not reuse retaining pin.
^ Drive retaining pin to 2 ± 0.5 mm (0.08 ± 0.020 inch) over the manual plate.

7. Install retaining pin into the transmission case and manual shaft.
a. Fit pinhole of the transmission case to pinhole of the manual shaft with a pin punch.





b. Use a hammer to tap the retaining pin into the transmission case.

CAUTION:
^ Do not reuse retaining pin.
^ Drive retaining pin to 5 ± 1 mm (0.20 ± 0.04 inch) transmission case.





8. Install O-rings to servo assembly.

CAUTION:
Do not reuse O-rings.
Apply petroleum jelly to O-rings. over the





9. Install return spring to servo assembly.





10. Install servo assembly in transmission case.





11. Using snap ring pliers, install snap ring to transmission case.





12. Install D-rings in reverse brake piston.

CAUTION:
^ Do not reuse D-rings.
^ Apply ATF to D-rings.





13. Install reverse brake piston in transmission case.





14. Install needle bearing to drum support edge surface.

CAUTION: Apply petroleum jelly to needle bearing.





15. Install seal rings to drum support.

CAUTION:
^ Do not reuse seal rings.
^ Apply petroleum jelly to seal rings.





16. Install spring retainer and return spring in transmission case.





17. Set the SST on spring retainer and install snap ring (fixing spring retainer) in transmission case while compressing return spring.

CAUTION: Securely assemble them using a flat-bladed screwdriver so that snap ring tension is slightly weak.





18. Install reverse brake retaining plate, drive plates, driven plates and dish plate in transmission case.

CAUTION: Take care with order of plates.





19. Assemble N-spring.
20. Install reverse brake retaining plate in transmission case.





21. Install snap ring in transmission case.





22. Measure clearance between retaining plate and snap ring. If not within specified clearance, select proper retaining plate.
Specified clearance "A":
Standard: 0.7 - 1.1 mm (0.028 - 0.043 inch)
Retaining plate: Refer to Specifications.





23. Install needle bearing to transmission case.

CAUTION:
^ Apply petroleum jelly to needle bearing.





24. Install revolution sensor to transmission case.

CAUTION:
^ Do not subject it to impact by dropping or hitting it.
^ Do not disassemble.
^ Do not allow metal filings, etc., to get on the sensor's front edge magnetic area.
^ Do not place in an area affected by magnetism.

Torque: 5.8 Nm (0.59 kg-m, 51 inch lbs.)





25. As shown in the right figure, use a drift to drive rear oil seal into the rear extension until it is flush.

CAUTION:
^ Do not reuse rear oil seal.
^ Apply ATF to rear oil seal.