Programming and Relearning
SETTING OF LIMIT SWITCHIf any of the following work has been done, set the limit switch (integrated in the motor).
- Removal and installation of regulator.
- Removal and installation of motor from regulator.
- Operate the regulators as a unit.
- Removal and installation of the glass.
Resetting
After installing each component to the vehicle, follow the steps.
1. With the door open, lift up and hold the power window switch until the door glass is fully closed.
2. Get inside the vehicle and close the door.
- You need to close the door so the door switch is fully depressed.
3. Press and hold the reset switch. While holding the reset switch, press down and hold the power window switch until the door glass is fully opened.
4. Relese the reset switch.Then, lift up and hold the power window switch until the door glass is fully closed.
5. Open the door to release the door switch. The door glass should partially move down.
CAUTION:
- Do not use the window auto function.
- Do not release the switch before the window is fully stopped.
FITTING INSPECTION
- Check that glass is securely fit into glass run groove.
- Lower glass slightly [approx. 10 to 20 mm (0.39 to 0.79 in)] and check the distance between the edge of glass and the body side welt. If the distance is not constant, adjust the glass position by loosening and tightening following bolts.
- Regulator mounting bolt and nut
- Glass and guide rail mounting bolt
- Raise the glass fully and adjust the glass top end and body side welt fitting with the adjusting bolt at the lower of the regulator rear rail.
NOTE:
- Turn the adjusting bolt clockwise to move the door glass upper end outward.
- Turn the adjusting bolt counterclockwise to move the door glass upper end inward.
- If water leaks, repair the fitting (Roadster only). Refer to "Repairing Method for Water Leakage Around Doors".