Seals and Gaskets: Service and Repair

REAR OIL SEAL

Removal and Installation
REMOVAL
For 2WD Models





1. Remove rear propeller shaft.
2. Remove dust seal and rear oil seal using suitable tool.

CAUTION: Do not damage rear extension.

For 4WD Models
1. Remove front and rear propeller shafts.
2. Remove transfer assembly.





3. Remove rear oil seal using Tool.
Tool number: KV381054S0 (J-34286)

CAUTION: Do not damage OD gear case.

INSTALLATION
Installation is the reverse order of removal.

For 2WD Models





^ Drive the new rear oil seal (1) and new dust seal (2) using Tools.
Tool number
: ST33200000 (J-26082)
: KV38100500 ( - )
Dimension "H1": 1.2 - 2.2 mm (0.047 - 0.087 inch)
Dimension "H2": 0.5 - 1.5 mm (0.020 - 0.059 inch)

CAUTION: Do not incline the dust seal and rear oil seal during installation.

(A): Seal lip

For 4WD Models





^ Drive the rear oil seal using Tool.
Tool number: ST33200000 (J-26082)
Dimension "A": -0.5 - 0.5 mm (-0.020 - 0.020 inch)

CAUTION: Do not incline the rear oil seal during installation.

^ Check the transmission oil level after installation.