Disassembly and Assembly
DISASSEMBLY AND ASSEMBLYRemove the regulator motor or crank assembly from the regulator assembly.
INSPECTION AFTER REMOVAL
Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.
- Wire wear
- Regulator deformation
- Grease condition for each sliding part
INSTALLATION
1. Install the regulator assembly.
a. Loosely install the top rear regulator bolt to use along with the temporary holds on the window motor or crank assembly to install the assembly in the door.
b. Install the top front regulator bolt.
c. Install the bottom front regulator bolt.
d. Install the bottom rear regulator bolt.
e. Tighten the top rear regulator bolt.
f. Install the top window motor or crank assembly bolt.
g. Install the lower window motor or crank assembly bolt
h. Install the rear window motor or crank assembly bolt.
Regulator and motor or crank assembly bolts : 5.7 N.m (0.58 kg-m, 50 in-lb)
2. If equipped, connect the harness connector to the regulator assembly.
3. Lower the glass and ensure that it is in both the front and rear glass channels. Tighten glass bolts.
Glass bolts : 6.1 N.m (0.62 kg-m, 54 in-lb)
4. Check the glass for proper fit. Refer to "FITTING INSPECTION".
5. On the drivers door, reset the motor (if equipped). Refer to "SETTING AFTER INSTALLATION".
6. Install the inside seal.
7. Install front door finisher. Refer to "FRONT DOOR".
SETTING AFTER INSTALLATION
Setting of Limit Switch
If any of the following work has been done, set the limit switch (integrated in the motor).
- Removal and installation of the regulator.
- Removal and installation of the motor from the regulator.
- Removal and installation of the glass.
- Removal and installation of the glass run.
Resetting
After installing each component, perform the following procedure to reset the limit switch.
1. Raise the glass to the top position.
2. While pressing and holding the reset switch, lower the glass to the bottom position.
3. Release the reset switch. Verify that the reset switch returns to the original position, if not, pull the switch using suitable tool.
4. Raise the glass to the top position.
CAUTION: Do not operate the glass automatically to raise the glass to the top position.