Sensor Rotor

SENSOR ROTOR

Removal and Installation
FRONT
The wheel sensor rotors are built into the wheel hubs and are not removable. If damaged, replace wheel hub and bearing assembly.

REAR
Removal
1. Remove axle shaft assembly.

NOTE: It is necessary to disassemble the rear axle to replace the sensor rotor.

2. Pull the sensor rotor off the axle shaft using Tool and a press.
Tool number: ST30031000 ( - )

Installation
1. Install new sensor rotor on axle shaft using a suitable length steel tube and a press. Make sure sensor rotor is fully seated.

CAUTION: Do not reuse the old sensor rotor.

2. Install axle shaft assembly.

CAUTION: Do not reuse the axle oil seal. The axle oil seal must be replaced every time the axle shaft assembly is removed from the axle shaft housing.