Wheel Sensors

WHEEL SENSORS

Removal and Installation

Exploded View BRC-35:

REMOVAL
1. Remove wheel sensor bolt.
^ When removing the front wheel sensor, first remove the disc rotor to gain access to the front wheel sensor bolt.
2. Pull out the sensor, being careful to turn it as little as possible.

CAUTION:
^ Be careful not to damage sensor edge and sensor rotor teeth.
^ Do not pull on the sensor harness.

3. Disconnect wheel sensor harness electrical connector, then remove harness from mounts.

INSTALLATION
Installation is in the reverse order of removal. Tighten wheel sensor bolt to specification.

CAUTION:
Installation should be performed while paying attention to the following:
^ Inspect wheel sensor O-ring, replace sensor assembly if damaged.
^ Clean wheel sensor hole and mounting surface with brake cleaner and a lint-free shop rag. Be careful that dirt and debris do not enter the axle.
^ Apply a coat of suitable grease to the wheel sensor O-ring and mounting hole.