Trim Panel: Service and Repair

BODY SIDE TRIM




Components

CAUTION:
- Wrap the tip of flat-bladed screwdriver with a cloth when removing metal clips from finishers.
- When removing or installing body side door welts, do not allow butyl seal to come in contact with pillar finisher.

Removal and Installation

LOWER DASH SIDE FINISHER

Removal
1. Remove front door welt.
2. Remove front kick plate.
3. Remove pushpin, release the clips and remove lower dash side finisher.

Installation
Installation is in the reverse order of removal.

CENTER PILLAR LOWER FINISHER

Removal
1. Remove front and rear door welts.
2. Remove seat belt anchor.
- On RH side, disconnect seat belt tension sensor.

3. Remove front and rear kick plates.
4. Remove center pillar lower finisher.

Installation
Installation is in the reverse order of removal.

CENTER PILLAR UPPER FINISHER

Removal
1. Remove center pillar lower finisher.
2. Remove seat belt shoulder anchor and D-ring. Refer to "Removal and Installation of Front Seat Belt".
3. Remove center pillar upper finisher.

Installation
Installation is in the reverse order of removal.

FRONT PILLAR LOWER FINISHER

Removal
1. Remove front door welt.
2. Remove front kick plate.
3. Remove the front pillar lower finisher.

Installation
Installation is in the reverse order of removal.

FRONT PILLAR UPPER FINISHER

Removal
1. Remove the front pillar lower finisher.
2. Remove the front pillar assist grip bolts and assist grip.
3. Remove the front pillar upper finisher.

Installation
Installation is in the reverse order of removal.

KICK PLATES

Removal
Release clips and remove front and/or rear kick plates.

Installation
Installation is in the reverse order of removal.