Seat Cushion Trim and Pad

SEAT CUSHION TRIM AND PAD

Disassembly

CAUTION:
- Front passenger seat is equipped with an Occupant Classification System sensor and control module. Do not disassemble front passenger seat cushion assembly or remove the trim as this will affect the Occupant Classification System calibration.
- Always replace passenger seat cushion as an assembly.
- When removed, the passenger seat cushion must always be placed pan side UP to prevent damage.
- During installation, the wire harness clips must be reinstalled in the holes they were originally in.
Do not add additional clips.
- The Occupant Classification System control module can only be replaced as part of the seat cushion assembly.

1. Remove the recline release lever.
2. Remove four bolts and the seat cushion assembly.




- On the fold flat passenger seat it is necessary to unclip the rear flap j-clip from the seat pan.

3. On the drivers seat only, remove the seat cushion trim and pad.
4. On the drivers seat only, remove the hog rings to separate the trim cover from the pad.

Assembly
Assembly is in the reverse order of disassembly.