Timing Components: Specifications
Timing Chain TensionerEM-52 Component (Part 1):
EM-52 Component (Part 2):
Crankshaft Pulley
Tighten crankshaft pulley bolt.
Torque 44.1 Nm (4.5 kg-m, 33 ft-lb)
Place a paint mark (A) on crankshaft pulley (2) aligning with the angle mark (C) on crankshaft pulley bolt (1). Tighten the bolt 90 degrees (one marks) (b).
Rotate crankshaft pulley in normal direction (clockwise when viewed from engine front) to confirm it turns smoothly.
Timing Cover
Tighten mounting bolts to the specified torque in numerical order as shown in the figure.
There are two types of mounting bolts. Refer to the following for locating bolts.
M10 bolts: 1, 2, 3, 4, 5, 6, 7 55.0 Nm (5.6 kg-m, 41 ft-lb)
M6 bolts: Except the above 12.7 Nm (1.3 kg-m, 9 ft-lb)
After all bolts tightened, retighten them to the specified torque in numerical order as shown in the figure.