ASCD Brake Switch
ASCD BRAKE SWITCHComponent Description
When the brake pedal is depressed, ASCD brake switch is turned OFF and stop lamp switch is turned ON. ECM detects the state of the brake pedal by this input of two kinds (ON/OFF signal). Refer to ASCD function.
CONSULT-III Reference Value in Data Monitor Mode
Wiring Diagram
A/T MODELS
EC-ASCBOF-01:
M/T MODELS
EC-ASCBOF-02:
Diagnosis Procedure
A/T MODELS
Step 1-2:
Step 2 (Continued)-7:
M/T MODELS
Step 1:
Step 1 (Continued)-3:
Step 3 (Continued)-9:
Step 9 (Continued)-10:
Component Inspection
ASCD BRAKE SWITCH
1. Turn ignition switch OFF.
2. Disconnect ASCD brake switch harness connector.
3. Check continuity between ASCD brake switch terminals 1 and 2 under the following conditions.
If NG, adjust ASCD brake switch installation, refer to BRAKE PEDAL and perform step 3 again.
ASCD CLUTCH SWITCH (M/T MODELS)
1. Turn ignition switch OFF.
2. Disconnect ASCD clutch switch harness connector.
3. Check continuity between ASCD clutch switch terminals 1 and 2 under the following conditions.
If NG, adjust ASCD clutch switch installation, perform step 3 again.