Pinout Values and Diagnostic Parameters

ECM Harness Connector Terminal Layout






ECM Terminal and Reference Value

PREPARATION




ECM (1) is located behind the passenger side instrument lower panel. For this inspection, remove passenger side instrument lower panel.

2 : ECM harness connector

ECM INSPECTION TABLE
Specification data are reference values and are measured between each terminal and ground. Pulse signal is measured by CONSULT-III.

CAUTION: Do not use ECM ground terminals when measuring input/output voltage. Doing so may result in damage to the ECMs transistor. Use a ground other than ECM terminals, such as the ground.

Terminals And Reference Value (Part 1):

Terminals And Reference Value (Part 2):

Terminals And Reference Value (Part 3):

Terminals And Reference Value (Part 4):

Terminals And Reference Value (Part 5):

Terminals And Reference Value (Part 6):

Terminals And Reference Value (Part 7):

Terminals And Reference Value (Part 8):

Terminals And Reference Value (Part 9):

Terminals And Reference Value (Part 10):

Terminals And Reference Value (Part 11):

Terminals And Reference Value (Part 12):