C1710

C1708 - C1711 DATA FROM TRANSMITTER NOT BEING RECEIVED

Description
Tire pressure data for one or more transmitters is not being received by the BCM.

DTC Logic

C1708-C1711:

DTC CONFIRMATION PROCEDURE

1. ID REGISTRATION AND VEHICLE DRIVING
1. Carry out ID registration of all transmitters.
2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
3. Check all tire pressures with CONSULT-III within 5 minutes.
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?
YES >> Inspection End.
NO >> Refer to "Data from Transmitter Not Being Received".

Data from Transmitter Not Being Received

FLASH CODE NO. 21, 22, 23 or 24

1. CHECK BCM
Drive for several minutes. Check all tire pressures with CONSULT-III.
Are all tire pressures displayed as 0 kPa?
YES >> GO TO 2.
NO >> GO TO 3.

2. CHECK TIRE PRESSURE RECEIVER CONNECTOR
Check tire pressure receiver connector for damage or loose connection.
Is tire pressure receiver connector damaged or loose?
YES >> Repair or replace tire pressure receiver connector.
NO >> Replace BCM, then GO TO 3.

3. PERFORM ID REGISTRATION
Carry out ID registration of all transmitters. Refer to WT-6, "ID Registration Procedure". ID Registration Procedure
Is there a tire that cannot register ID?
YES >> Replace malfunctioning transmitter, then GO TO 5.
NO >> GO TO 4.

4. DRIVE VEHICLE
1. Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
2. Check all tire pressures with CONSULT-III within 15 minutes after vehicle speed becomes 17 km/h (11 MPH).
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?
YES >> Inspection End.
NO >> GO TO 5.

5. ID REGISTRATION AND VEHICLE DRIVING
1. Carry out ID registration of all transmitters.
2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
3. Check all tire pressures with CONSULT-III within 5 minutes.
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?
YES >> Inspection End.
NO >> Proceed to the inspection applicable to DTC.

Special Repair Requirement
Perform preliminary check. Refer to WT-5, "Preliminary Check". Preliminary Check