Rear Suspension

COIL SPRING

RSU-7 Component:

Removal and Installation

REMOVAL
1. Remove rear tires from vehicle using power tool.
2. Remove wheel sensor from wheel hub and bearing assembly.

CAUTION: Do not pull on wheel sensor harness.

3. Separate brake tube from wheel cylinder.
4. Set jack under rear suspension beam.





5. Remove shock absorber lower side bolt.
6. Gradually lower the jack, and then remove coil spring and rear spring rubber seat (upper and lower).

INSPECTION AFTER REMOVAL
Check coil spring and spring rubber seat for deformation, cracks, and damage, and replace it if a malfunction is detected.

INSTALLATION
^ Installation is in the reverse order of removal. For tightening torque, refer to RSU-7, "Component".





^ When installing spring, be sure to securely install the spring end position aligned to flush of rear spring rubber seat (lower) as shown.