Control Device Removal and Installation

Control Device Removal and Installation

CONTROL DEVICE COMPONENTS

AT-203 Components:

CONTROL CABLE COMPONENTS

AT-204 Components:

REMOVAL

CAUTION: Make sure that parking brake is applied before removal/installation.

1. Place the selector lever in the "N" position.
2. Remove the center console assembly.





3. Disconnect the A/T device harness connector (1).
4. Remove the key interlock cable from the control device assembly.





5. Remove the bolts (A) from the control device assembly (1).
6. Remove exhaust front tube, center muffler and heat plates.





7. Remove the plate (1) from the control device assembly.
<---: Vehicle front





8. Remove the lock plate (1) from the control cable (2).
<---: Vehicle front
9. Remove the control cable (2) from the control device assembly.





10. Insert flat-bladed screwdrivers at points (A) and (B) as shown, and press both tabs (E) and (F) at the front (C) and rear (D) slightly toward the center of the control device assembly to remove the control device assembly from the underside of the vehicle.
<---: Vehicle front

INSTALLATION
Installation is in the reverse order of removal.





^ When installing the control cable (1) to the control device assembly (2), make sure that the control cable (1) is fully pressed in with the ribbed surface (A) facing downward from the vehicle.
<---: Vehicle front
^ After installation is completed, adjust and check the A/T position. Refer to AT-207, "Adjustment of A/T Position" and AT-207, "Checking of A/T Position".
Adjustments
Procedures