Without Intelligent Key System

GLASS HATCH AJAR SWITCH


Description

Detects glass hatch open/close condition.





GLASS HATCH AJAR SWITCH


Diagnosis Procedure

Regarding Wiring Diagram information, BCM (Body Control Module).
1.CHECK GLASS HATCH AJAR SWITCH INPUT SIGNAL
With CONSULT-III
Check glass hatch ajar switch "GLASS HATCH SW" in DATA MONITOR mode with CONSULT-III.
- When glass hatch is open:

GLASS HATCH SW :ON

- When glass hatch is closed:

GLASS HATCH SW :OFF

Without CONSULT-III
Check voltage between BCM connector M19 terminals 42 and ground.











Is the inspection result normal?
YES - Glass hatch ajar switch circuit is OK.
NO - GO TO 2
2.CHECK GLASS HATCH AJAR SWITCH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect glass hatch ajar switch and BCM.
3. Check continuity between BCM connector (A) M19 terminal 42 and glass hatch ajar switch connector (B)
D503 terminal 1.

42 - 1 :Continuity should exist





4. Check continuity between BCM connector (A) M19 terminal 42 and ground.

42 - Ground :Continuity should not exist

Is the inspection result normal?
YES - GO TO 3
NO - Repair or replace harness.
3.CHECK GLASS HATCH AJAR SWITCH
Check continuity between glass hatch ajar switch connector terminal 1 and ground.











Is the inspection result normal?
YES - Intermittent Incident.
NO - Replace glass hatch ajar switch.