Crash Zone Sensor

CRASH ZONE SENSOR


Removal and Installation


REMOVAL

CAUTION:
- Before servicing the SRS, turn the ignition switch off, disconnect both battery terminals and wait at least 3 minutes.
1. Disconnect the negative and positive battery terminals, then wait at least 3 minutes.





2. Remove crash zone sensor nuts and shield from support member.
3. Disconnect the crash zone sensor harness connector.
4. Remove crash zone sensor.

CAUTION:
- Replace crash zone sensor if it has been dropped or sustained an impact.
- Do not disassemble crash zone sensor.

INSTALLATION
Installation is in the reverse order of removal.
- After the work is complete, perform self-diagnosis to check that no malfunction is detected. Component Tests and General Diagnostics.