Removal And Installation

SEAT

Removal and Installation


REMOVAL

1.Remove the headrest. (Except net seat)
2.Remove the mounting bolts on the rear side of the seat.
- Slide the seat to the front-most position.
- Remove the bolt caps.
- Remove the mounting bolts.
3.Remove the mounting bolts on the front side of the seat.
- Slide the seat to the rear-most position.
- Remove the bolt caps.
- Remove the mounting bolts.
4.Set seatback in a standing position.
5.Disconnect harness connector under the seat and remove harness securing clips.

CAUTION:
Before removal, turn ignition switch OFF, disconnect battery negative terminal and then wait 3
minutes or more.
6.Remove seat from the vehicle.

CAUTION:
When removing and installing, use shop cloths to protect parts from damage.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
- Before installation, turn ignition switch OFF, disconnect battery negative terminal and then wait 3
minutes or more.
- Clamp the harness in position.