Without Power Door Locks

ILLUMINATION

Removal and Installation


ILLUMINATION CONTROL SWITCH

Removal





The illumination control switch is replaced as a part of the combination meter. Service and Repair.
Installation
Installation is in the reverse order of removal.

A/T FINISHER LAMP

Removal
1.Remove A/T finisher from center console. A/T Finisher.





2.Rotate A/T finisher lamp socket (2) with bulb (3) counterclockwise, then pull away from finisher (1).
Installation
Installation is in the reverse order of removal.
Bulb Replacement
1.Remove A/T finisher from center console. A/T Finisher.





2.Remove A/T finisher lamp socket (1), then pull bulb (2) straight out away from socket.
3.Install the bulb (2) into the A/T finisher socket (1).
AT finisher lamp bulb: 12V - 3W
4.Install A/T finisher in center console. A/T Finisher.