Part - 2

48.Remove reverse brake snap ring using two flat-bladed screwdrivers.
NOTE:
Press out snap ring from the transmission case oil pan side gap using a flat-bladed screwdriver, and remove it using a another screwdriver.
49.Remove reverse brake retaining plate from transmission case.
- Check facing for burns, cracks or damage. If necessary, replace the plate.





50.Remove N-spring from transmission case.





51.Remove reverse brake drive plates, driven plates and dish plate from transmission case.
-Check facing for burns, cracks or damage. If necessary, replace the plate.





52.Remove snap ring using suitable tool.





53.Remove spring retainer and return spring from transmission case.





54.Remove seal rings from drum support.





55.Remove needle bearing from drum support edge surface.





56.Remove reverse brake piston from transmission case using compressed air. .

CAUTION:
Care should be taken not to abruptly blow air. It makes the piston incline, and as a result, it becomes hard to disassemble the pistons.





57.Remove D-rings from reverse brake piston.





58.Knock out retaining pin using suitable tool.





59.Remove manual shaft retaining pin using suitable tool.





60.Remove manual plate (with parking rod) from manual shaft.





61.Remove parking rod from manual plate.





62.Remove manual shaft from transmission case.





63.Remove manual shaft oil seals using suitable tool.

CAUTION:
Do not scratch transmission case.





64.Remove detent spring and spacer from transmission case.





65.Remove snap ring from transmission case using suitable tool.





66.Remove servo assembly (with return spring) from transmission case.





67.Remove return spring from servo assembly.





68.Remove O-rings from servo assembly.

CAUTION:
Do not reuse O-rings.





69.Remove needle bearing (1) from rear extension (2WD models)
or adapter case (4WD models).





70.Remove parking actuator support from rear extension (2WD
models) or adapter case (4WD models).





71.Remove parking pawl (with return spring) and pawl shaft from rear extension (2WD models) or adapter case (4WD models).





72.Remove return spring (1) from parking pawl (2).





73.Remove rear oil seal from rear extension (2WD models) or adapter case (4WD models) using suitable tool.

CAUTION:
Do not scratch rear extension (2WD models) or adapter case (4WD models).