Rear Final Drive C200

REAR FINAL DRIVE

Removal and Installation


REMOVAL


CAUTION:
- Do not damage spline, companion flange and front oil seal when removing propeller shaft.
- Before removing final drive assembly or rear axle assembly, disconnect ABS sensor harness connector from the assembly and move it away from final drive/rear axle assembly area. Failure to do so may result in sensor wires being damaged and sensor becoming inoperative.
1.Remove the rear disc brake rotors. Removal And Installation.
2.Remove the rear propeller shaft. Removal And Installation (2S1330), Removal And Installation (3S1310), Removal And Installation (3S1330) or Removal And Installation (2S1330-BJ-100).
3.Disconnect the following components from the rear final drive.
- ABS sensor wire harness





- Parking brake cable
- Brake hoses and tubes
4.Support rear final drive assembly using a suitable jack.
5.Remove rear shock absorber lower bolts. Removal and Installation.
6.Remove leaf spring U-bolt nuts. Rear Suspension.
7.Remove rear final drive assembly

CAUTION:
Secure rear final drive assembly to the jack while removing it.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:
Check the rear final drive assembly differential gear oil and refill as necessary. Check for fluid leaks.
Checking Differential Gear Oil.