Changing

M/T OIL

Changing


DRAINING

1.Start the engine and let it run to warm up the transmission.
2.Stop the engine. Remove the transmission drain plug and drain the oil.
3.Set a gasket on the drain plug and install it to the transmission. Tighten the drain plug to the specified torque. Overhaul.

CAUTION:
Do no reuse gasket.

FILLING






1.Remove the filler plug. Fill with new oil until oil level reaches the specified limit near the filler plug hole.
Oil grade and Viscosity:

2.After refilling the oil, check oil level. Set a gasket to the filler plug, then install it to the transmission. Tighten the filler plug to the specified torque. Overhaul.

CAUTION:
Do not reuse gasket.