C1130

C1130 ENGINE SIGNAL

Description

ABS actuator and electric unit (control unit) and ECM exchange the engine signal via CAN communication line.


DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn the ignition switch OFF
and wait at least 10 seconds before conducting the next test.
- GO TO 2.

2. DTC REPRODUCTION PROCEDURE

1.Turn the ignition switch OFF to ON.
2.Perform self-diagnosis for "ABS" with CONSULT.
Is DTC "C1130" detected?
YES- Proceed to diagnosis procedure. .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK ENGINE SYSTEM

1.Perform self-diagnosis for "ENGINE" with CONSULT. Repair or replace items indicated, then Perform self-diagnosis for "ENGINE" with CONSULT.
2.Perform self-diagnosis for "ABS" with CONSULT.
Is any item indicated on the self-diagnosis display?
YES- Repair or replace the affected part.
NO- INSPECTION END


Special Repair Requirement


1. ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION

Always perform the neutral position adjustment for the steering angle sensor, when replacing the ABS actuator and electric unit (control unit) or steering angle sensor and removing steering angle sensor. Refer to BRC76, "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION : Special Repair Requirement".
- END