Work Procedure

ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION

Work Procedure


ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION


1. CHECK VEHICLE CONDITION

Park vehicle with steering wheel in the straight-ahead position.
Is the vehicle parked with steering wheel in the straight-ahead position?
YES- GO TO 2.
NO- Park vehicle with steering wheel in the straight-ahead position.

2. ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION

1.Connect CONSULT to the vehicle.
2.Start CONSULT and select "AVM", "WORK SUPPORT", and "STEERING ANGLE SENSOR ADJUSTMENT" in sequence.
3.Touch "START" to perform steering angle sensor neutral position.

CAUTION:
Never touch the steering wheel during steering angle sensor adjustment.
4.After a lapse of approximately 10 seconds, touch "END".
5.Turn ignition switch OFF. Turn it ON again.
- GO TO 3.

3. SELF-DIAGNOSIS OF AV CONTROL UNIT

Perform self-diagnosis of around view monitor control unit to check that DTC "U0428" is not detected.
Is DTC "U1232" detected?
YES- Perform adjustment again.
NO- Completion of adjustment.