Removal And Installation

KEY INTERLOCK CABLE

Removal and Installation


REMOVAL


CAUTION:
Check that parking brake is applied before removal/installation.
1.Shift selector lever to "P" position.
2.Remove selector lever knob. Exploded View Without Manual Mode (without manual mode), Exploded View With Manual Mode (with manual mode).
3.Removal center console assembly. Exploded View.





4.Slide slider (A) toward casing cap (B) while pressing tabs (C) on slider to separate slider from adjust holder (D).





5.Remove steering column lower cover and instrument driver lower cover. Exploded View.





6.Remove clip (A) from holder (B).
7.Remove key interlock cable (1) from key cylinder (2).
8.Remove key interlock cable.

INSTALLATION

Note the following, and install in the reverse order of removal.





- Temporarily install adjust holder (A) to key interlock rod (B). Install casing cap (C) to cable bracket (D) on CVT shift selector assembly.

CAUTION:
- Never bend or twist key interlock cable excessively when installing.
- Check that casing caps is firmly secured in cable bracket on
CVT shift selector assembly after installing key interlock cable to cable bracket on CVT shift selector assembly.
- If casing cap is loose [less than 39.2 N (4.0 kg, 8.8 lb) removing force], replace key interlock cable.





- With the detent rod (A) pressed fully to the end, slider the slider (B)
to the key interlock rod (C) side, and install adjust holder (D) and key interlock rod.

CAUTION:
- Never press tabs when holding slider.
- Never apply any force at a right angle to key interlock rod when sliding.