Removal And Installation Without Manual Mode

CVT SHIFT SELECTOR

WITHOUT MANUAL MODE : Removal and Installation


REMOVAL

1.Disconnect the battery cable from the negative terminal.
2.Shift selector lever to "N" position.





3.Slide knob cover (1) below selector lever downward.

CAUTION:
Be careful not to damage knob cover.
4.Pull lock pin (2) out of selector lever knob (3).
5.Remove selector lever knob and knob cover.





6.Remove knob fin (1) using a flat-bladed screwdriver (A).

CAUTION:
Be careful not to damage selector lever knob.
7.Remove overdrive control switch (2).
8.Remove center console assembly. Exploded View.





9.Disconnect shift lock solenoid connector (A).
10.Remove shift lock solenoid (1) using a feeler gauge (B).





11.Disconnect CVT shift selector connector (A).
12.Shift selector lever to "P" position.
13.Remove key interlock cable (1) from CVT shift selector assembly. Exploded View.
14.Remove control cable (2) from CVT shift selector assembly.
Exploded View.
15.Remove CVT shift selector assembly.





16.Remove position lamp.





17.Unhook (black arrow) position indicator plate (1) for removal.






INSTALLATION

Note the following, and install in the reverse order of removal.





When installing control cable (1) to CVT shift selector assembly (2), check that control cable is fully pressed in with the ribbed (A) surface facing upward.