For Mexico

B1134 SIDE MODULE LH

Description


DTC B1134 [OPEN] SIDE MODULE LH

For front LH side air bag module, crash is judged by main "G" sensor output signal (left side: left satellite sensor, right side: right satellite sensor) and sub "G" sensor (right and left GP in center unit).

OPERATION

In the case of a collision whose acceleration exceeds the specified level, the ignition materials are ignited by electric ignition system. The system burns and introduces the chemical reaction of gas generating materials to generate hot gases that flow into the air bag through a filter and expand the bag.

STRUCTURE

Front LH side air bag module mainly consists of air bag and inflator which inflates air bag.

INSTALLATION

Front LH side air bag module is installed on the side of front seatback with fixed nuts.


DTC Logic


DTC DETECTION LOGIC

With CONSULT
DTC No. Index ("SELF-DIAG [CURRENT]"), ("SELF-DIAG [PAST]" or "TROUBLE DIAG RECORD")






DTC CONFIRMATION PROCEDURE (With CONSULT)


1. INSPECTION START

Turn ignition switch ON.
- GO TO 2.

2. CHECK SELF-DIAG RESULT

Check the screen of CONSULT.
Is malfunctioning part detected?
YES- .
NO-INSPECTION END.

DTC CONFIRMATION PROCEDURE (Without CONSULT)

NOTE:
- SRS will not enter diagnosis mode if no malfunction is detected in user mode.

1. INSPECTION START

Turn ignition switch ON.
- GO TO 2.

2. CHECK AIR BAG WARNING LAMP

Check the warning lamp status.
Is malfunctioning part detected?
YES- Testing and Inspection.
NO-INSPECTION END.


Diagnosis Procedure


With CONSULT


WARNING:
- Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least 3 minutes. (To discharge backup capacitor.)
- Do not use unspecified tester or other measuring device.

DIAGNOSTIC PROCEDURE


1. CHECK HARNESS CONNECTOR

Check the connection of harness connector.
Is the inspection result normal?
YES- GO TO 2.
NO- Repair or replace harness connector.

2. CHECK WIRING HARNESS

Check the wiring harness externals.
Is the inspection result normal?
YES- GO TO 3.
NO- Replace wiring harness.

3. CHECK FRONT SIDE AIR BAG MODULE

1.Replace front LH side air bag module.
2.Check the screen of CONSULT.
Is the inspection result normal?
YES-INSPECTION END.
NO- Check the intermittent incident. Intermittent Incident.