ABS

C1121, C1123, C1125, C1127 OUT ABS SOL

Description

The solenoid valve increases, holds or decreases the fluid pressure of each brake caliper according to the signals transmitted by the ABS actuator and electric unit (control unit).


DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn the ignition switch OFF
and wait at least 10 seconds before conducting the next test.
- GO TO 2.

2. DTC REPRODUCTION PROCEDURE

1.Turn the ignition switch OFF to ON.
2.Perform self-diagnosis for "ABS" with CONSULT.
Is DTC "C1121", "C1123", "C1125" or "C1127" detected?
YES- Proceed to diagnosis procedure. .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK CONNECTOR

1.Turn the ignition switch OFF.
2.Disconnect ABS actuator and electric unit (control unit) harness connector.
3.Check terminal for deformation, disconnection, looseness, etc.
Is the inspection result normal?
YES- GO TO 2.
NO- Replace or repair error-detected parts.

2. CHECK SOLENOID VALVE POWER SUPPLY

Check voltage between ABS actuator and electric unit (control unit) harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- Perform trouble diagnosis for battery power supply. Battery Power Supply.

3. CHECK SOLENOID VALVE GROUND CIRCUIT

Check continuity between ABS actuator and electric unit (control unit) harness connector and ground.





Is the inspection result normal?
YES- Replace ABS actuator and electric unit (control unit). ABS.
NO- Repair or replace error-detected parts.