Moonroof Motor Assembly

MOONROOF MOTOR ASSEMBLY

Removal and Installation


REMOVAL

1.Close glass lid.





2.Remove the front room/map lamp assembly from headlining (4).
Refer to "Removal and Installation" Removal And Installation.
White arrow indicates : Front

3.Remove moonroof motor assembly screws (A).
4.Disconnect harness connector (3) and remove moonroof motor assembly (1) from moonroof unit assembly front end rail.

CAUTION:
Do not run the removed moonroof motor assembly as a single unit.

INSTALLATION

1.Move moonroof motor assembly laterally little by little so that the gear is completely engaged into the wire on the moonroof unit assembly, and the mounting surfaces become parallel. Install the moonroof motor assembly screws and tighten.

CAUTION:
Before installing the motor, be sure to place the link and wire assembly in the symmetrical and fully closed position.
NOTE:
If necessary, insert a suitable tool into the drive key and rotate right or left slightly to assist in complete moonroof motor gear alignment.
2.Remainder of installation is in the reverse order of removal.
3.Synchronize moonroof motor assembly with moonroof unit assembly.