Steering Switch

STEERING SWITCH

Description

When one of the steering switches is pushed, the resistance in the steering switch changes the signal to identify which button is controlling the information display.


Diagnosis Procedure

Regarding Wiring Diagram information, refer to "Wiring Diagram" [1][2]Electrical Diagrams.

1. CHECK STEERING SWITCH CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect combination meter harness connector M24 and spiral cable harness connector M30.
3.Check continuity between combination meter harness connector M24 and spiral cable harness connector
M30.





4.Check continuity between combination meter harness connector M24 and ground.





Is the inspection results normal?
YES- Inspection End.
NO- Repair or replace harness or connectors.


Component Inspection


1. CHECK STEERING SWITCH RESISTANCE

Check resistance between the following steering switch terminals.





Is the inspection results normal?
YES- GO TO 2.
NO- Replace steering wheel switch. Refer to "Removal and Installation" Removal And Installation.

2. CHECK SPIRAL CABLE

Check continuity between the following spiral cable terminals.





Is the inspection results normal?
YES- Inspection End.
NO- Replace spiral cable. Refer to "Removal and Installation" Service and Repair.