Fuel Level Sensor Unit

FUEL LEVEL SENSOR UNIT

Disassembly and Assembly












Disassembly

NOTE:
Before disassembly, note the proper placement of the wires to the correct terminals and correct wire routing to the terminals.
1.Disconnect the red, white (A) and double black connector (B).





- Press the tabs on the terminals to release the locking tabs.

(C): Fuel pump harness connector






2.Release the two clips and remove the fuel temperature sensor from the pump assembly.





3.Release the tab (A) and slide the level sending unit module and float arm assembly (B) up to remove.

Assembly

Assembly is the reverse order of disassembly.
NOTE:
- Ensure proper placement of the wires to the correct terminals and correct wire routing to the terminals.
- After connecting terminals, ensure they are securely locked and can not be pulled out.
- When installing the level sending unit, push down until the tab is locked into place.