Operation CHARM: Car repair manuals for everyone.

Work Procedure




ID REGISTRATION PROCEDURE

Work Procedure

NOTE:
One of the following procedures must be used for TPMS registration. Tire Pressure Sensor Activation Tool J45295 will not work on this vehicle.

TPMS REGISTRATION WITH SIGNAL TECH II TOOL (J-50190)

NOTE:
The Signal Tech II must be updated with software version 1.1.45 or newer in order to perform this procedure.
1.Adjust the tire pressure for all tires to the recommended value. Refer to "Tire" Specifications.
2.Turn on the Signal Tech II tool (J-50190) and select "TPMS Check" from the main menu.
3.Select vehicle model and year.





4.When prompted, hold the Signal Tech II against the side of the left front tire, near the valve stem.
5.With the tool held at a 0 to 15 degree angle to the tire, press and release the "OK" button to activate the sensor. Once the sensor is activated, the tool will display the tire pressure.
6.Repeat steps 4 and 5 for the remaining tires in this order: right front, right rear and left rear.
7.When prompted, connect the tool to the data link connector. The tool will connect to the BCM, read the VIN, read sensor IDs and check for TPMS DTCs. Along with DTCs detected, one of the following will be displayed next to each wheel:
- N/A - Not applicable because no ID found by the tool
- OK - Wheel and sensor are in original position
- NEW - New ID found compared to BCM
- RT - Wheel has been rotated
- Low Press - Low tire pressure
8.If no DTC is present or the repair has been completed, press the "OK" button to register the IDs and clear
DTCs.
9.Test drive the car to ensure that the TPMS light goes out and no warning messages are present.
10.Print a report for your records. Refer to the Signal Tech II User Guide for instructions.

TPMS REGISTRATION WITH CONSULT

1.Adjust the tire pressure for all wheels to match the list below.





2.Turn the ignition switch ON.
3.Using Consult, select "WORK SUPPORT" in BCM (AIR PRESSURE MONITOR). Then, select "ID REGIST."
4.Select Start on "ID REGIST" screen.
5.Drive the vehicle at a speed greater than 40 km/h (25 MPH) for 3 minutes or more.
6.After ID registration for all wheels is complete, press "End" to finish ID registration.





7.Adjust the tire pressures for all tires to the recommended value. Refer to "Tire" Specifications.