Theft Deterrent/Shock Sensor Customization

Theft Deterrent Arm/disarm Customization Table:

IMPORTANT:
^ If the ignition switch is moved to the OFF" position while in the customization procedure, the theft deterrent/shock sensor customization procedure will he terminated and the system will remain in the most recent mode.

1. Remove the "MALL PGM" fuse from the fuse panel.
2. Turn the ignition to the "ACC" position. One to four bongs will occur to indicate which Body Control Module (BCM) version is installed on the vehicle.
3. Turn the park lamp switch ON" then "OFF". The seat belt telltale flashes and the chime will bong one to four times, equal to the current customization mode, to indicate which mode the vehicle is in.

Each time the park lamp switch is turned "ON", the mode number will advance. A transition past mode four will repeat starting again at mode one. To exit and save the current customization, turn the ignition "OFF" and replace the "MALL PGM" fuse back into the fuse panel. If desired, customize other features before reinstalling the "MALL PGM" fuse into the fuse panel.