AM-FM Stereo W/COMP Disc Player & AUTO Tone Control (UN0)

UNO Radio:

PLAYING THE RADIO
PWR VOL: Press this knob to turn the system on and off. To increase volume, turn the knob clockwise. Turn it counterclockwise to decrease volume. The knob is capable of rotating continuously.

RECALL: Press this button to recall the station being played. If you press the button when the ignition is off, the clock will show for a few seconds.

SCV: This system has a feature called Speed-Compensated-Volume (SCV). With SCV, the audio system adjusts automatically to make up for road and wind noise as you drive. Set the volume at the desired level. Move the control ring behind the upper knob clockwise to adjust the SCV. Then, as you drive, SCV automatically increases the volume, as necessary, to overcome noise at any particular speed. The volume level should always sound the same to you as you drive. If you don't want to use SCV turn the control all the way down. Each detent on the control ring allows for more volume compensation at a faster rate of speed.

FINDING A STATION
AM-FM: Press this button to switch between AM, FM1 and FM2. The display shows your selection.

TUNE: Press this knob lightly so it extends. Turn it to choose radio stations. Push the knob back into its stored position when you're not using it.

SEEK: Press the right or left arrow to go to the next higher or lower station and stay there. The sound will mute while seeking.

SCAN: Press one of the "SEEK" arrows for 2 seconds, and "SCAN" will appear on the display. Use "SCAN" to listen to stations for a few seconds. The radio will go to a station, stop for a few seconds, then go on to the next station. Press "SEEK" again to stop scanning. The sound will mute while scanning.

PUSHBUTTONS
The six numbered pushbuttons let you return to your favorite stations. You can set up to 18 stations (six AM, six FM1 and six FM2). Just:
1. Press "AM-FM" to select the band.
2. Tune in the desired station.
3. Press "AUTO TONE" to select the equalization that best suits the type of station selected.
4. Press and hold one of the six numbered buttons. The sound will mute. When it returns, release the button. Whenever you press that numbered button, the station you set will return and the "AUTO TONE" equalization that you selected will also be automatically selected for that button.
5. Repeat the steps for each pushbutton.

P.SCAN: Press this button to listen to each of your favorite stations stored on your pushbuttons for a few seconds. The radio will "SCAN" through each of the stations stored on your pushbuttons, except those stations with weak reception. The "AUTO TONE" setting stored for that pushbutton will be automatically chosen. Press "P.SCAN" or one of the pushbuttons again to stop scanning. "P.SCAN" will be displayed whenever the tuner is in the "P.SCAN" mode. The channel number (P1-P6) will appear momentarily just before the frequency is displayed.

SETTING THE TONE
BASS: Press this knob lightly so it extends. Turn the knob clockwise to increase bass and counterclockwise to decrease bass. When you use this control, the radio's AUTO TONE setting will switch to manual.

TREB: Press this knob lightly so it extends. Turn the knob clockwise to increase treble and counterclockwise to decrease treble. When you use this control, the radio's AUTO TONE setting will switch to manual. If a station is weak or noisy, you may want to decrease the treble.

Push these knobs back into their stored positions when you're not using them.

AUTO TONE: This feature allows you to choose preset bass and treble equalization settings designed for classical, news, rock, pop, country/western and jazz stations "C/W" will appear on the display when you first press "AUTO TONE." Each time you press it, another setting will appear on the display. Press it again after "JAZZ" appears and the "AUTO TONE" display will go blank. Tone control will return to the "BASS" and "TREB" knobs. Also, if you use the "BASS" and "TREB" knobs, control will return to them and the "AUTO TONE" display will go blank.

ADJUSTING THE SPEAKERS
BAL: Press this knob lightly so it extends. Turn the knob clockwise for right speakers and counterclockwise for left speakers. The middle position balances the sound between the speakers.

FADE: Press this knob lightly so it extends. Turn the knob clockwise to adjust the sound to the front speakers and counterclockwise for the rear speakers. The middle position balances the sound between the speakers.

Push these knobs back into their stored positions when you're not using them.

PLAYING A COMPACT DISC
Insert a disc partway into the slot, label side up. The player will pull it in. The disc should begin playing. The display will show CD and the CD symbol.

If you're driving on a very rough road or if it's very hot, the disc may not play and "ERR" (error) may appear on the display. Press "RECALL" to take "ERR" off the display. When things get back to normal, the disc should play. If the disc comes out, it could be that:
^ The disc is upside down.
^ It is dirty, scratched or wet.
^ It is very humid. (If so, wait about an hour and try again.)

PREV (1): Press this button or the left "SEEK" arrow to the start of a current track. If you hold the button or press it more than once, the player will continue moving back through the disc. The sound will mute while seeking.

RDM (2): Press this button to hear the tracks in random, rather than sequential, order. "RANDOM" will show on the display. Press "RDM" again to turn off random play. "RDM" is reset to off when the disc is ejected.

NEXT (3): Press this button or the right "SEEK" arrow to go to the next track. If you hold the button or press it more than once, the player will continue moving forward through the disc. The sound will mute while seeking.

REV (4): Press and hold this button to quickly reverse within a track. Release it to play the passage. You can use the counter reading on the display to locate a passage more easily.

FWD (6): Press and hold this button to advance quickly within a track. Release it to resume playing. You can use the counter reading on the display to locate a passage easily.

AM-FM: Press this button to play the radio when a disc is in the player. The letters CD will go off the display.

RECALL: Press this button to see which track is playing. Press it again within 5 seconds to see how long it has been playing (elapsed time). The track number also appears when you change the volume or when a new track starts to play.

AM-FM: Press this button to play the radio when a disc is in the player. The letters CD will go off the display.

CD AUX: Press this button to change to the disc function when the radio is on. A CD icon will appear on the display when the disc is in the player, whether it is active or not.

EJECT: Press this button to remove the disc. The radio will play. The disc will start at the first track when you reinsert it.

If you turn off the ignition or radio with a disc in the player, it will stay in the player. When you turn on the ignition or system, the disc will start playing where it was stopped. If you press "EJECT" but don't remove the disc, the player will pull the disc back in to protect it after about 1 minute.