Hinge Pillar Tie Bar (Cross Car Beam) Replacement

Description:

Remove or Disconnect
1. Battery ground (negative) cable.
2. Instrument panel trim pad.
3. Instrument panel upper trim.
4. Mall module.
5. DRL module.
6. ABS module.
7. Steering column.
8. HVAC module.
9. Extension ducts.
10. Center air outlet.
11. Defroster duct.
12. Bolts/screws from cross car beam to body.
13. Cross car beam from body.

Install or Connect

NOTICE: Refer to Service Precautions.

1. Position cross car beam to body.
2. Bolts/screws to cross car beam to body.

Tighten
^ Bolts/screws to 25 Nm (18 lb ft).

3. Defroster duct.
4. Center air outlet.
5. Extension ducts.
6. HVAC module.
7. Steering column.
8. ABS module.
9. DRL module.
10. Mall module.
11. Wiring harness.
12. Instrument panel upper trim.
13. Instrument panel trim pad.