Piston and Connecting Rod Disassemble

^ TOOLS REQUIRED
- J 24086-C Piston Pin Remover/Installer

CAUTION: HANDLE THE PISTON CAREFULLY. WORN PISTON RINGS ARE SHARP AND MAY CAUSE BODILY INJURY.





1. Remove the piston rings from the piston. Use a suitable tool in order to expand the piston rings. Do not reuse the piston rings.

IMPORTANT: Do not put any load on the piston during disassembly.

2. Select fork insert J 24036-310. Install the fork upside down into the press.
3. Place the piston and connecting rod assembly into the J 24086-C and press out the piston pin. Ensure that the connecting rod is above the fork when installing the piston and connecting rod assembly into the press.
4. Mark the piston pin to the piston from which the pin was removed.