Input and Third Sprag Clutches Disassemble

1. Disassemble the input and third spray clutch assemblies (653, 665) from the input clutch housing assembly (632).

Important: After you remove the snap ring, discard the ring. Replace the snap ring with a new ring when you reassemble the sprag.





2. Use a tapered blade screwdriver in order to remove the snap ring (717) from the outer race retainer of the input clutch sprag.
3. Remove the third sprag assembly (665) and the input sprag assembly (653) from the inner race and retainer assembly (661).
4. Remove the inner race and retainer assembly (661) and remove the input sun gear spacer (667) from the input sun gear (668).





5. Remove the third spray retainer (717).
6. Remove the end bearing (719) and the center bearing (721) from the sprag outer races.

Important: Do not disassemble the sprag elements.

7. Remove the sprag elements (720, 722) from the outer races.