Cleaning & Inspection

1. The following parts should not be placed in carburetor cleaner:
a. Rubber parts, electrical solenoids, plastic parts, vacuum diaphragms and pump plunger.
b. Choke coil and cover assembly.
c. Fuel filter.
d. Air horn, unless idle air bleed has been removed.
2. Thoroughly clean all metal parts. Make sure all fuel passages and metering parts are free of burrs and dirt. Do not pass drills or wires through jets and passages.
3. Inspect upper and lower casting surfaces for damage.
4. Thoroughly inspect all internal parts for damage, wear, burrs, binding or distortion.